Honda Odyssey OEM 2 Button Key Fob

This is a Factory OEM (Original Equipment Manufacturer) Honda Odyssey 2 Button keyless entry remote, aka “key fob”.

1995-1998 Honda Odyssey

Obtain all remote transmitters for this vehicle. Entering programming mode erases all remotes, so all remotes must be programmed during this procedure.

1. Open driver’s door.

2. Press and hold the UNLOCK switch on the drivers door and continue to hold until instructed to release.

3. Within ten seconds, insert the key in the ignition and remove it five times.

4. Insert the key a sixth time and leave it in the ignition. Vehicle will respond by locking and unlocking the doors indicating the vehicle’s in programming mode.

5. Press the LOCK OR UNLOCK button on the remote. Vehicle will respond by locking and unlocking the doors indicating the vehicle has programmed that remote.

6. To program additional remotes: Repeat step 5. within 10 seconds for each remote.

7. RELEASE the UNLOCK button on the drivers door and test all remotes.

Obtain all remote transmitters for this vehicle. Entering programming mode erases all remotes, so all remotes must be programmed during this procedure.

1. Turn ignition to ON (ll). (ON is the position just shy of starting the vehicle without cranking engine)

2. Press and hold the valet/disarm button located between the AM/FM and CD/TAPE button. The vehicle will respond by locking and unlocking the doors, indicating the vehicle is in programming mode. (You must continue to hold the valet button until instructed to release)

3. Within five seconds, press the LOCK or UNLOCK button on the remote. The vehicle will respond by locking and unlocking the doors, indicating the vehicle has programmed that remote.

4. Within ten seconds, Repeat step 3. for all additional remotes to be programmed.

5. Release valet/disarm button to exit programming mode. Test all remotes.

1. Remove dasboard panel located below steering wheel to the left to access keyless entry receiver. You will need to remove a couple of screws to remove panel.

2. Turn the ignition to ON. (ON is the position just shy of starting your vehicle without cranking the engine)

3. Locate the green button on the side of the keyless entry receiver. It will be inside a small hole that can be accessed with a small pointy objct such as a pen.

4. Using the pointy object, press the green button until the exterior lights or the LED on the drivers side dash illuminate then release.

5. Within 5 seconds of step 4. Press and release the top button on the remote. The LED should turn OFF, the siren chirps once and the front marker lights will flash if remote successfully programmed.

6. Repeat steps 4 and 5 for any additional remotes to program.

7. Turn the ignition to off, test remotes, replace panel.

OEM Key Fobs:

We are proud to offer true OEM key fobs direct to you at up to 80% off dealer prices. There is a catch though, so here it goes:

You need to know the only way to get a NEW OEM key fob is to go to a dealer or authorized reseller of OEM parts, and you will pay dealer prices if you do this and spend hundreds of dollars.

Our Products:

The key fob you are going to purchase from us is used or as we like to say “previously loved”. We recycle OEM key fobs and put them through a rigorous refurbishing process so we can guarantee our products and offer them at a reasonable price along with saving the environment. Oh, and we are not robbing you of your hard earned dollars like the stealership does. So if you are good with all of this what are you waiting for? Make your life easier, order a key fob from us and save the world!